|
The Recovery O2
masks can be used to provide oxygen to animals. The mask has a 22mm x hose barb
adapter on the inlet side, allowing you to connect either oxygen tubing
(included) or the adapter can be removed to allow the attachment of a standard
22mm breathing circuit. The mask also has dual vents on the sides to allow
unrestricted inhalation and exhalation. If oxygen flow is set too low for
patient requirement, the vents will allow the patient to inhale ambient air. If
oxygen flow is set too high for patient requirement, the vents will allow excess
air to escape. The masks and tubing can be cleaned with a dilute chlorhexidine
solution or mild soap and water.
Recovery O2 Small
#32490B15 (3 1/2”H, 3 5/8”D, 1 1/4” hole in diaphragm)
Recovery O2 Large
#32490B10 (6”H, 5 1/2”D, 2 1/4” hole in diaphragm)
Recovery O2
Feline #32490B16 (3 3/4”H, 3 5/8”D, 1 1/8” hole in diaphragm)
Recovery O2 Mask Set V7148 (includes one mask of
each size and tubing)
Oxygen Recovery Mask
The
oxygen recovery masks can be used to provide oxygen to animals that are in
respiratory distress. The mask has a 22mm x hose barb adapter on the inlet
side, allowing you to connect either oxygen tubing (included) or the adapter can
be removed to allow the attachment of a standard 22mm anesthesia machine
breathing circuit. The mask also has dual vents on the sides to allow
unrestricted inhalation and exhalation. If oxygen flow is set too low for
patient requirement, the vents will allow the patient to inhale ambient air. If
oxygen flow is set too high for patient requirement, the vents will allow excess
air to escape.
Operation:
1. Connect
O2 tube to O2 supply or remove 22mm/O2 fitting and connect to an anesthesia
machine.
2.
Seal mask over patients mouth and nose
3.
Set appropriate O2 flow rate for the
patient.
Feline mask: 1-3 liters
Small Canine mask: 3-5 liters
Large Canine mask: 5-7 liters
Note: For long term insufflation, oxygen should
flow through a bubble type humidifier to prevent mucosal drying.
Cleaning:
The masks and tubing should be cleaned after each
use with a dilute chlorhexidine solution or mild soap and water. For the best
method of cleaning remove the diaphragm and 22mm adapter from the mask. Then dry
parts and reinstall diaphragm & adapter for the next use.
|
